View Single Post
Old 12-26-2008, 07:15 PM   #47
Phenix_Rider
WERA White Plate
 
Phenix_Rider's Avatar
 
Join Date: Feb 2008
Location: Renton, WA
Moto: Ninja 650R
Posts: 1,920
Default

Well, it runs- sorta. On one and a half cylinders. The left side is firing fine, the center is flaky, and the right not at all. Got the overflow problem fixed though- Dad got the only float needle and seat in 60 miles. Still have a slow leak from a pinhole in the right fuel line. Found a weird crystal formation on it today- fuel must have atomized coming out the hole and frozen. Definitely have spark on all three, so that's a good thing. Did a compression test too- in the range of 135-150 all three.

Quote:
Originally Posted by '73 H1 Triple View Post
One other thing to check --- the petcock.

Make sure it's in the "ON" position and not in the "prime" position. The prime position will make the carbs overflow.
Hmmm.... I'll bet that's part of it. I never really looked- just figured it needed new seals. Should only flow in "ON" when it has engine vacuum right? Well, we just found the tube broke where it goes up and around under the tank

You sir, are a fine human being
__________________
Quote:
So you think you're ready to ride? So if i ran up to you with a belt sander would you feel safe????

Last edited by Phenix_Rider; 12-26-2008 at 07:50 PM..
Phenix_Rider is offline   Reply With Quote