Quote:
Originally Posted by NONE_too_SOFT
I've never had to deal with this before, but i cant figure out for the life of me how to install my bar ends. I took the one i did have off, and just tried putting the new one on in place. worked fine, but stuck out way too far. i thought i understood the mechanics to it (the mount you screw the actual bar end into screws into the clipon, if im not mistaken) but couldnt adjust that mount at all.
so i go to the otherside, and have the exact opposite problem. the mount was recessed too far back.
Any ideas?
|
Swap them left to right?
Use some stainless washers to shim out the recessed side to match?