Quote:
Originally Posted by NONE_too_SOFT
thx tig, but it didnt even get to that point. I used the water bottle meathod (bleeding the fluid into water so air cant get back into the system) just fine.
After some tweaks and tinkering i got it all done pretty damn quick. let it gravity feed for a couple resevoirs full, then pumped all the bubbles out until i got to the tiny bubbles, then pumped them all out til i got no bubbles, then a few more pumps just to make sure. Then closed the bleed and did the same on the other side. No bubbles. Im going to go finish it up by trying these steps out.
Have great pressure now, just wish i could actually ride the bike out to test the new lines and HH pads.
|
Good! Well for good measure, pump them up and tie them back overnight. That will allow any air stuck in there to rise to the res.