Too loose = bad, too tight = worse. If you chain is loose, you will hear it slapping around. If its too tight, you may not hear anything or some type of popping. Over tightened chains can mess your shit up. They can wear out or break a counter shaft in little or no time at all.
First of all, buy a steel, millimeter ruler to check the alignment with. The tick marks on the swingarm are not precise enough to get the alignment right. Next, loosen everything up and re-adjust the chain so that you have the correct amount of slack, and a good alignment. Do each side, a little at a time, and alternate back and forth. If you go too far and the chain is too tight, loosen the adjustment nuts up, knock the wheel forward, and start again. Now, tighten the axle nut down and test ride it.
__________________
I'm sick and tired of being bored.
|