More projects...
Waterproofing...
Pulled the front LEDs
Pulled the plate apart and preped it for waterproofing
Yanked the rear LEDs
Sprayed them all with the silicone board sealant
Attacked the plate frame for the vertical flaw. The wire channel can and does collect water.
Drill a hole in the bottom of the channel
Then sealed the extra/non-used holes in the backing plate with silicone
Onward to the connector waterproofing
Then we pulled his gas tank... a nice setup these K9's have
Protect the paint
OFF
The BDM way
Found some frame damage that the BDM dealer tech had replaced the tank bushings but obviously didn't do anything about this
So we covered it and then taped over it... will need to possible paint it the next time we pull the tank.
Our waterproofed way
Don't forget some of the hidden ones under the side covers
