brake cleaning

No Worries · 07-17-2011, 11:43 PM

Could also be the fork alignment. When replacing the front wheel, the axle bolts could be tightened too much. Or a spacer in the wrong position. The bottom of the forks would then be closer together than the top. This binds the fork movement up and down, and could cause the calipers to bind.

I measured the distance between forks on my old Suzuki decades ago with a set of calipers. I had to shim the axle to get the fork distance perfect, and the rotors equal distance from the forks. I haven't had to replace the fork seals on it in 45K miles. And the brake pads just skim the rotors. But I bet if I took out those shims, the brake pads would bind against the rotors, and the forks would bind.

07-17-2011, 11:43 PM	#15
No Worries Keyboard Racer Join Date: Feb 2008 Location: Mile High City Moto: Old Superbikes Posts: 1,016	Could also be the fork alignment. When replacing the front wheel, the axle bolts could be tightened too much. Or a spacer in the wrong position. The bottom of the forks would then be closer together than the top. This binds the fork movement up and down, and could cause the calipers to bind. I measured the distance between forks on my old Suzuki decades ago with a set of calipers. I had to shim the axle to get the fork distance perfect, and the rotors equal distance from the forks. I haven't had to replace the fork seals on it in 45K miles. And the brake pads just skim the rotors. But I bet if I took out those shims, the brake pads would bind against the rotors, and the forks would bind.