SeaFoam for winter storage, ruff running, and so much more

Dnyce · 01-10-2009, 02:18 PM

u guys put it in the oil too? doesnt mess with the clutch?

Cutty72 · 01-10-2009, 02:19 PM

Quote:

Originally Posted by Dnyce

u guys put it in the oil too? doesnt mess with the clutch?

I don't... but then again I change the oil right away in the spring.

'73 H1 Triple · 01-10-2009, 06:43 PM

Quote:

Originally Posted by Dnyce

u guys put it in the oil too? doesnt mess with the clutch?

Quote:

Originally Posted by Cutty72

I don't... but then again I change the oil right away in the spring.

It's better to change the oil & filter before you put the bike away in the fall.

That way you have fresh, pure oil on all your machined surfaces instead of used, contaminated oil.

Jeff

Cutty72 · 01-10-2009, 07:42 PM

Quote:

Originally Posted by '73 H1 Triple

It's better to change the oil & filter before you put the bike away in the fall.

That way you have fresh, pure oil on all your machined surfaces instead of used, contaminated oil.

Jeff

says whom?
I've never seen any proof that one is better than the other. I figure I'd rather have fresh oil in it when I start riding it than when it's just sitting in storage for 5-6 months.

Dnyce · 01-11-2009, 03:12 AM

in the video it mentioned adding it to your oil, in thru the carb/vacuum line, and the rest in your tank. triple attack lol. that wasnt for storage, that was just proper usage according to the vid. but that was a car. i dont winterize, never will. just curious about usage.

i decided not to use it yet, but i will. already got the can

marko138 · 01-11-2009, 09:36 AM

I dont change my oil before or after winter storage. Never have, never will. I dont see the point. I change at the recommended intervals.

marko138 · 03-28-2009, 10:49 PM

Gas man or others....Seafoam...ok to put this shit in with the gas that already has Sta-bil or is that ill-advised?

Cutty72 · 03-28-2009, 11:03 PM

Quote:

Originally Posted by marko138

Gas man or others....Seafoam...ok to put this shit in with the gas that already has Sta-bil or is that ill-advised?

Shouldn't cause a problem. I have done it before in snowblowers/lawnmowers.

Mr Lefty · 03-28-2009, 11:41 PM

Quote:

Originally Posted by marko138

Gas man or others....Seafoam...ok to put this shit in with the gas that already has Sta-bil or is that ill-advised?

no problem... I put staybil in my gas on my ZZR before I stored it... ran a can of Seafoam through (over a couple tanks) when it first came out of storage...

then again... I did loop and total it... but I'm about 80% sure that wasn't caused by the Seafoam

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-10-2009, 02:18 PM	#1
Dnyce flyin high Join Date: Mar 2008 Location: cali Moto: 10speed huffy w/cards in the spokes Posts: 2,318	u guys put it in the oil too? doesnt mess with the clutch?

01-11-2009, 03:12 AM	#5
Dnyce flyin high Join Date: Mar 2008 Location: cali Moto: 10speed huffy w/cards in the spokes Posts: 2,318	in the video it mentioned adding it to your oil, in thru the carb/vacuum line, and the rest in your tank. triple attack lol. that wasnt for storage, that was just proper usage according to the vid. but that was a car. i dont winterize, never will. just curious about usage. i decided not to use it yet, but i will. already got the can