Slip On...and a PC3???

z06boy · 03-26-2009, 10:22 AM

I'm pretty sure with just a slip-on you do not have to install the PCIII.

However to get the most out of it and to assure correct A/F ratio you would need this.

A slip-on isn't really going to add more than 2 or 3 hp most likely so even with the PCIII you won't get much if any more but if put on a dyno...with the PCIII you can adjust the ratio if it isn't exactly where you want it.

If you're trying to save money then I think you would be fine without it.

If you were adding a full system and even the upgraded air filter then I'd say the PC3 was a must.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-26-2009, 10:22 AM	#6
z06boy Letzroll Join Date: Feb 2008 Location: Lake Norman area, NC Moto: 07 Red R1 & 07 Blue R6 Posts: 5,265	I'm pretty sure with just a slip-on you do not have to install the PCIII. However to get the most out of it and to assure correct A/F ratio you would need this. A slip-on isn't really going to add more than 2 or 3 hp most likely so even with the PCIII you won't get much if any more but if put on a dyno...with the PCIII you can adjust the ratio if it isn't exactly where you want it. If you're trying to save money then I think you would be fine without it. If you were adding a full system and even the upgraded air filter then I'd say the PC3 was a must.