Bar ends?

[Amber Lamps]

Originally Posted by NONE_too_SOFT

I've never had to deal with this before, but i cant figure out for the life of me how to install my bar ends. I took the one i did have off, and just tried putting the new one on in place. worked fine, but stuck out way too far. i thought i understood the mechanics to it (the mount you screw the actual bar end into screws into the clipon, if im not mistaken) but couldnt adjust that mount at all.

so i go to the otherside, and have the exact opposite problem. the mount was recessed too far back.

Any ideas?

Swap them left to right? Use some stainless washers to shim out the recessed side to match?