Should i break down

Gas Man · 04-16-2009, 04:25 PM

Quote:

Originally Posted by marko138

Fair enough, my friend.

Don't cut him slack... there is no excuse. Bikes are expensive and to cheap out on maintance is just horrible.

Antwanny · 04-16-2009, 09:23 PM

ended up saving 70 $ and went vortex spools and a powerstand no complaints craftsmanship on both are superb (at the moment) I wanted woodcraft but couldnt see shelling out 50$ in shipping alone

marko138 · 04-17-2009, 09:28 AM

Quote:

Originally Posted by Antwanny

ended up saving 70 $ and went vortex spools and a powerstand no complaints craftsmanship on both are superb (at the moment) I wanted woodcraft but couldnt see shelling out 50$ in shipping alone

I had Vortex spools on my Zuk. No complaints. I also have a Vortex rear stand. Solid.

zed · 04-17-2009, 10:40 AM

whats the difference in spools?

I made my own stand.

Antwanny · 04-18-2009, 10:07 PM

id rather have woodcraft

marko138 · 04-19-2009, 10:03 AM

Quote:

Originally Posted by Antwanny

id rather have woodcraft

Then buy Woodcraft, kid.

jtemple · 04-19-2009, 10:32 AM

I'm a cheap fucker. When I finally bit the bullet and bought some Pitbull stands, the first time I used them, I decided that they'd be worth the money if they cost 3x as much as they did. They work on any bike, with nothing more than a $10 pin swap for the front stand and are tough enough to outlast any bike!

Antwanny · 04-19-2009, 07:53 PM

Quote:

Originally Posted by marko138

Then buy Woodcraft, kid.

yea see that money, tree mine never got delivered.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-16-2009, 09:23 PM	#2
Antwanny WERA White Plate Join Date: Apr 2008 Location: Maryland Posts: 1,047	ended up saving 70 $ and went vortex spools and a powerstand no complaints craftsmanship on both are superb (at the moment) I wanted woodcraft but couldnt see shelling out 50$ in shipping alone

04-17-2009, 10:40 AM	#4
zed yellow don't corner well Join Date: Feb 2009 Location: Kansas City, KS Moto: 06 ZX10R Posts: 1,243	whats the difference in spools? I made my own stand.

04-18-2009, 10:07 PM	#5
Antwanny WERA White Plate Join Date: Apr 2008 Location: Maryland Posts: 1,047	id rather have woodcraft

04-19-2009, 10:32 AM	#7
jtemple Geek Join Date: Feb 2008 Location: Papillion, Nebraska Moto: 2011 Husqvarna TE630 Posts: 1,437	I'm a cheap fucker. When I finally bit the bullet and bought some Pitbull stands, the first time I used them, I decided that they'd be worth the money if they cost 3x as much as they did. They work on any bike, with nothing more than a $10 pin swap for the front stand and are tough enough to outlast any bike!