Wheel Striping

racedoll · 05-03-2009, 09:56 PM

WD-40 works best on sticker type stuff versus goo-gone but I'd just watch using either on your rims and getting close to your tire.

RiderRageGoneBAD · 05-03-2009, 10:00 PM

i use a heat gun and then after the bulk is off, just clean it up with some 3M adhesive remover!

t-homo · 05-04-2009, 12:04 AM

Quote:

Originally Posted by RiderRageGoneBAD

i use a heat gun and then after the bulk is off, just clean it up with some 3M adhesive remover!

I'd probably take his advice.

ZUKIMON · 05-06-2009, 10:59 PM

3M adhesive remover is the shit!! FTW

05-03-2009, 10:00 PM	#2
RiderRageGoneBAD Supporting Vendor Join Date: Jul 2008 Location: Cherry Hill, NJ Moto: 2008 Kawasaki Ninja ZX6R Posts: 52	i use a heat gun and then after the bulk is off, just clean it up with some 3M adhesive remover! __________________ Custom Motorcycle Graphics - Wheel Stripes - Light Tinting - Ready2Cut Decals http://www.eastcoastgrafix.org

05-06-2009, 10:59 PM	#4
ZUKIMON Is this thing on? Join Date: Feb 2009 Location: Ashe Co, NC (Near Boone) Moto: '01, 929RR Posts: 398	3M adhesive remover is the shit!! FTW __________________ Dirty Harry said there's nothing wrong with a little shooting, as long as the right people get shot.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-03-2009, 09:56 PM	#1
racedoll AMA Supersport Join Date: Nov 2008 Moto: '04 Kawasaki ZX6RR Posts: 3,392	WD-40 works best on sticker type stuff versus goo-gone but I'd just watch using either on your rims and getting close to your tire.