|
 |
 |
 |
 |
 |
 |
 |
 |
|
|
09-18-2009, 09:01 AM
|
#1 |
|
Crotch Rocket Curmudgeon
Join Date: Nov 2008
Location: Here to integrity
Moto: Li'l red baby Ninja
Posts: 7,482
|
__________________
Insert free thought here. |
|
|
|
09-19-2009, 01:34 AM
|
#2 | |
|
WSB Champion
Join Date: Nov 2008
Location: Anaheim, CA
Moto: 2009 Kawi ZX6R
Posts: 5,570
|
Quote:
Sounds like you have the wrong bearing set esp. if the numbers don't match. Didn't you put new rod bearings in this engine?
__________________
Train Hard Ron Paul - 2012 Mark of Excellence GM |
|
|
|
|
|
09-19-2009, 01:41 AM
|
#3 |
|
WSB Champion
Join Date: Nov 2008
Location: Anaheim, CA
Moto: 2009 Kawi ZX6R
Posts: 5,570
|
The connecting rods are 38ftlbs, not 32...at least according to the latest GM service info.
• Install the connecting rod bolt nuts. Tighten • Tighten the connecting rod bolt nuts to 52 N·m (38 lb ft). • Loosen the connecting rod bolt nuts 1 full turn. • Tighten the connecting rod bolt nuts to 52 N·m (38 lb ft).
__________________
Train Hard Ron Paul - 2012 Mark of Excellence GM |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
