V-Twin FTW

[tommymac]

Originally Posted by Hydrant

You'll have that on the larger scale projects.

I've done that too. You think you know what every connection is, but a few weeks go by, and then its time to get out the ol' dealer manual and start searching.


I think I'm going to do some more airbox work, brakes / rotors, and get a new clutch. I put new fluid in over the summer, SS lines a few years back and still doesn't have the bite it used to.

Are the clutches on the S and the R similar? I need to replace the clutch on my S. I picked up a clear cover and an annodized pressure plate. When I last tried running the bike I had a major oil leak, wasnt sure if the pushrod seal went or was from the countershaft.

[Hydrant]

Originally Posted by tommymac

Are the clutches on the S and the R similar? I need to replace the clutch on my S. I picked up a clear cover and an annodized pressure plate. When I last tried running the bike I had a major oil leak, wasnt sure if the pushrod seal went or was from the countershaft.

That I don't know.

Where did you get your anodized pressure plate from?

I've got the riflemans clear cover.


I need to get back over to TLzone to see what's the latest and greatest, haven't been over there for a while.

[tommymac]

Originally Posted by Hydrant

That I don't know.

Where did you get your anodized pressure plate from?

I've got the riflemans clear cover.


I need to get back over to TLzone to see what's the latest and greatest, haven't been over there for a while.

I honestly dont remember, it wa sone of the GB's on tlzone, not sure if it was rifleman who made them, I got a few other bits as well from them.

[OneSickPsycho]

Originally Posted by tommymac

any space on the subframe, a friend mounted a horn like that on his ducati there.

There would be if I wasn't planning on relocating the battery and as much of the electronics as possible in there... oh, and chopping half of that shit off...

[tommymac]

Originally Posted by OneSickPsycho

There would be if I wasn't planning on relocating the battery and as much of the electronics as possible in there... oh, and chopping half of that shit off...

Fine, I wont offer any ideas anymore

If thats the case could you squeeze one in the old battery tray or something else is going there.

[OneSickPsycho]

Originally Posted by tommymac

Fine, I wont offer any ideas anymore

If thats the case could you squeeze one in the old battery tray or something else is going there.

Actually, that's a pretty solid idea... I could make a bracket to hold it there, but the whole idea of moving the battery was to lose the ugliness on the side, so in that case I might as well keep the battery there...

Shit, I think I might just leave the battery there... That would be much easier than rerouting all that wiring... I'll probably just get a nifty battery box cover or something...