Let's brainstorm.

TommyHotWheel · 03-06-2011, 12:37 AM

Puller combined with heat and melt some parafin wax on to the shaft while its hot and then try to pull it off.

Triple · 03-06-2011, 12:51 AM

There isn't enough space between the cog and the block to fit a puller.

I tried heating the cog with the torch-- for about five minutes straight-- and then hitting it with an upside-down can of air duster, but it still wouldn't break.

03-06-2011, 12:37 AM	#1
TommyHotWheel Imported from Detroit Join Date: Nov 2008 Location: Michigan Moto: 2001 Suzuki TL1000R Posts: 989	Puller combined with heat and melt some parafin wax on to the shaft while its hot and then try to pull it off. __________________ Cry Havok! And let slip the hogs of war!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-06-2011, 12:51 AM	#2
Triple uncomfortably numb Join Date: Nov 2008 Location: JOH-JAH! Moto: WR250R & Bonneville Posts: 409	There isn't enough space between the cog and the block to fit a puller. I tried heating the cog with the torch-- for about five minutes straight-- and then hitting it with an upside-down can of air duster, but it still wouldn't break.